Any one know how to fix oil in gas problem in a chain saw?

this morning i put gas in the oil and oil in the gas. if any one can help that would be great


thanks {:)Any one know how to fix oil in gas problem in a chain saw?
1 half bottle of chainsaw oil to


2 gallons gas.Any one know how to fix oil in gas problem in a chain saw?
Drain the oil resevoir then flush it a couple of times by adding oil in and draining a few times. For the gas tank, you can probably just burn it through. If you put a lot in though I would drain then refill with gas b/c it will wet your plugs(with the oil) and you will have to keep cleaning them to get it started again until it is minimal enough just to burn through.





hope it helps
You'll need to drain the gas from the oil tank and refill with chain bar oil. If you have a manual oiler, pump it until you no longer smell the gas and the oil is thick. The oil in the gas tank has to be drained. Flush the gas tank with gas/oil mix. If you haven't tried to start it with the Chain bar oil in it, you may get lucky and flush the tank a couple of times and refill with gas/oil mix and it 'll start. If not you may have to take the gas lines off and flush them, and/or take the carburetor off and clean the oil out of it. Don't try to run the chain bar oil throught he engine, it's not made to burn and could cause engine damage.